What does a bath to shower conversion cost in Moray?
Our guide range in Moray is £1,900–£4,800 including VAT. Prices in Moray run at about 4% below the UK guide, based on Scotland labour rates.
Tray and enclosure
- Thermostatic shower, re-tiling
Walk-in shower
- Large tray and frameless screen
Level-access floor
- Level entry, linear drain
Guide prices for Moray including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Moray?
Most of Moray is supplied with soft water. If that holds for your street in Elgin, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If the bath in your Elgin home is mainly used for storing things, a walk-in shower in the same space is a quick, contained job.
What the job includes
- Grab rails and a fold-down seat if you want them
- A survey of the bath space, the waste position, the floor and your water system
- A low-profile tray, or a former and tanking for a level-access floor
- Boarding, tanking and re-tiling of the shower walls
- Repair or replacement of floorboards where the bath has left them soft or damaged
- Removal of the bath, panel and taps, and disposal of the waste
Decisions to make first
Enclosure or walk-in
An enclosure with a door keeps all the water in and suits a shorter space. A walk-in panel makes the most of the full 1700 mm length an old bath leaves.
Safety extras
A fold-down seat, grab rails and a slip-resistant tray cost little at the time of fitting and are much harder to add later.
How much to re-tile
Re-tile just the shower walls, or take the chance to re-tile the whole room so new and old tiles never have to match.
Low tray or level floor
A low-profile tray has a small lip. A level-access floor removes the step altogether but needs a former, tanking and a linear drain.
Rules that apply in Scotland
Converting a bath to a shower does not need planning permission. The shower area is a special location under BS 7671, with 30 mA RCD protection on every circuit and at least IPX4 fittings in zone 1 above the tray up to 2.25 m. A shower pump can only be used on a gravity system with a cold tank, never on the mains. Where the conversion adapts the home for a disabled person, the work can be zero-rated for VAT under HMRC VAT Notice 701/7.
In Scotland, a bath to shower swap in the same position rarely needs a building warrant, but a level-access floor that alters drainage or structure may. For adaptation help, councils run a Scheme of Assistance rather than Disabled Facilities Grants.