What does bathroom plumbing work cost in Moray?
Our guide range in Moray is £600–£3,800 including VAT. Prices in Moray run at about 4% below the UK guide, based on Scotland labour rates.
Like-for-like
- Pressure test
Partial re-route
- Basin or shower moved
New layout
- Pumped waste or macerator
Guide prices for Moray including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Moray?
Water across much of Moray is soft. In soft water, taps, wastes and toilet pans scale up slowly, so brushed and matt finishes are a safe choice. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Elgin home has a gravity system with a loft tank, we check the head of water before recommending a shower or a pump.
What the job includes
- Shower pumps on gravity systems, and macerators or pumped wastes where gravity drainage cannot reach
- New hot and cold pipework in copper or plastic, properly clipped, and insulated where it runs through cold spaces
- A check of your hot water system, and the pressure and flow rate at the bathroom
- Isolation valves on every fitting, so taps, cisterns and valves can be serviced without draining the system
- The WC connected to the soil stack, or a new branch where the WC is moving
- Draining down and isolating supplies, with the rest of the house back on water as soon as possible
Decisions to make first
Concealed or exposed valves
Concealed shower valves look neater but need an access route for servicing. Exposed bar valves are easier to reach and replace.
Copper or plastic
Copper is rigid and suits pipes on show or near the boiler. Plastic is quicker under floors and inside walls, and long runs need fewer joints.
Pipe routes
Drilling through the middle of joists, rather than notching the tops, keeps the floor strong. Routes are planned with the joist direction in mind.
Shower supply
Combi boilers and unvented cylinders give mains pressure. A gravity system with a cold tank may need a pump, but a pump must never be connected to the mains.
Rules that apply in Scotland
New WCs, taps, showers and valves must meet the water fittings rules where you live: a maximum 6-litre flush for new WCs, backflow protection, and no pump connected directly to the mains supply, because shower pumps are only for gravity systems with a cold tank. Unvented hot-water cylinders must be installed by a G3-qualified installer, and any work on a gas boiler by a Gas Safe registered engineer.
In Scotland, the Scottish Water Byelaws 2014 cover new water fittings, with the same 6-litre flush limit and backflow rules. Altering drainage may need a building warrant, so check before moving a WC or adding a new connection to the stack.