- Postcode districts
- M34, SK14, SK16
- Nearby
- Denton, Dukinfield and Stalybridge
- Guide price
- £235–£550
- Typical time on site
- half a day
- Water
- Soft across most of Greater Manchester
- Survey
- Free, at your home
What does a bathroom extractor fan cost in Hyde?
As a guide, budget £235 to £550 including VAT for a bathroom extractor fan in Hyde; your written quote will pin it down. Prices in North West England run at about 6% below the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Extractor fan
- Fan with timer or humidistat
Inline fan
- Ducting to a roof or soffit vent
Continuous extract
- Good for windowless rooms
Guide prices for Hyde including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Hyde
We work right across Hyde — M34, SK14 and SK16 — and in neighbouring Denton and Dukinfield.
In Hyde, as anywhere, the age of the house decides a lot: pipe sizes, floor construction and where the soil stack runs. For windowless bathrooms in Hyde homes, continuous extract that boosts on humidity often works better than a fan tied to the light switch. If your Hyde bathroom has black mould on the ceiling or silicone, the fan and its duct are the first things we check.
Supplies across most of Greater Manchester are soft. Even so, condensation is the bigger problem in any bathroom, and a properly sized extractor is what deals with it. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- A check of the room, any existing fan or vent, and the shortest route to the outside
- Wiring by a qualified electrician, with an isolator outside the room and RCD protection
- Run-on timer, humidistat or light-linked switching set up to suit how the room is used
- Rigid or semi-rigid ducting kept short and straight, and insulated where it crosses a cold loft
Decisions to make first
Replacement air
A fan needs air to replace what it removes, so leave a gap of around 10 mm under the door or fit a door grille. A sealed room starves the fan.
Timer or humidistat
A timer keeps the fan running after the light goes off. A humidistat starts it whenever moisture rises, which suits rooms where people forget.
Rules that apply in England
In England, Approved Document F sets bathroom extract at 15 l/s for an intermittent fan or 8 l/s for continuous extract. Wiring a new fan alters a circuit in a room with a bath or shower, so it is notifiable under Part P.
