- Postcode districts
- N9, N18, N21
- Nearby
- Tottenham, Enfield and Chingford
- Guide price
- £550–£4,400
- Typical time on site
- half a day to 3 days
- Water
- Very hard across most of Greater London
- Survey
- Free, at your home
What does a new shower cost in Edmonton?
In Edmonton, a new shower typically costs £550–£4,400 including VAT, based on London prices. Prices in London run at about 25% above the national guide, mainly because of labour rates. The figure depends on the size of the room, whether anything moves, and the products you pick.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Edmonton including VAT. Your itemised written quote after the free survey is the price that counts.
Working in Edmonton
We work right across Edmonton — N9, N18 and N21 — and in neighbouring Tottenham and Enfield.
London homes in Edmonton often mean stairs, permits and neighbours below; we plan the logistics as carefully as the bathroom. If the shower in your Edmonton home swings between hot and cold, a thermostatic valve is usually the fix. For Edmonton homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply.
Water across much of Greater London is very hard. If your supply in Edmonton is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier.
What the job includes
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- A bath screen, tray or enclosure where the shower is new
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
Decisions to make first
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Rules that apply in England
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.
