What does a walk-in shower cost in Ayrshire?
Our guide range in Ayrshire is £2,400–£5,800 including VAT. Prices in Ayrshire run at about 4% below the UK guide, based on Scotland labour rates.
Tray and screen
- Low-profile tray and 8 mm glass panel
Frameless upgrade
- Concealed thermostatic valve
Tiled level floor
- Floor and wall tiling
Guide prices for Ayrshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Ayrshire?
Most of Ayrshire is supplied with soft water. If that holds for your street in Kilmarnock, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If you are planning ahead in Kilmarnock for easier access, a low-profile walk-in tray gives most of the benefit without a full wet room.
What the job includes
- Wall tiling, with an optional recessed niche
- A thermostatic valve with a riser rail, a fixed head or both
- An 8 mm or 10 mm toughened glass panel with a wall profile and support arm, or a frameless fixing
- A low-profile stone-resin tray, or a floor former with a linear drain for a tiled level floor
- Tanking to the shower walls, and to the floor where it is tiled
- Removal of the old bath or enclosure and making good to the walls and floor
Decisions to make first
Valve
An exposed bar valve with a riser rail is easy to fit and service. A concealed valve hides the pipework and suits a fixed overhead head.
Glass thickness
8 mm toughened glass is standard; 10 mm feels heavier and more solid. An easy-clean coating keeps limescale off clear glass in hard-water areas.
Tray or tiled floor
A tray is quicker, costs less and has a small lip. A tiled floor with a linear drain sits level with the rest of the room and lets one tile run throughout.
Niche
A recessed shelf in the back wall keeps bottles off the tray. It has to be planned at first fix and tanked like the rest of the wall.
Rules that apply in Scotland
Fitting a walk-in shower does not need planning permission. The light and fan above the shower are in zone 1 up to 2.25 m and must be at least IPX4, or IPX5 where water jets are used, with 30 mA RCD protection on every circuit under BS 7671. Under the water fittings rules, a shower pump may only be used on a gravity system with a cold tank, never on the mains, and the shower needs protection against water flowing back into the supply.
In Scotland, a straight swap from a bath or enclosure to a walk-in shower does not normally need a building warrant, though altering the drainage may. Water fittings must meet the Scottish Water Byelaws 2014.