What does a walk-in shower cost in Edinburgh?
Our guide range in Edinburgh is £2,400–£5,800 including VAT. Prices in Edinburgh run at about 4% below the UK guide, based on Scotland labour rates.
Tray and screen
- Thermostatic mixer and riser rail
Frameless upgrade
- Large-format tiles, niche
Tiled level floor
- Floor former, tanking and linear drain
Guide prices for Edinburgh including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Edinburgh?
Water across much of Edinburgh is soft. If that holds for your street in Queensferry, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Queensferry shower enclosure has a leaking door seal or a cracked tray, a walk-in panel removes the door altogether.
What the job includes
- Removal of the old bath or enclosure and making good to the walls and floor
- Tanking to the shower walls, and to the floor where it is tiled
- A survey of the space, the waste position, water pressure and the hot-water system
- A thermostatic valve with a riser rail, a fixed head or both
- A low-profile stone-resin tray, or a floor former with a linear drain for a tiled level floor
- Wall tiling, with an optional recessed niche
Decisions to make first
Glass thickness
8 mm toughened glass is standard; 10 mm feels heavier and more solid. An easy-clean coating keeps limescale off clear glass in hard-water areas.
Niche
A recessed shelf in the back wall keeps bottles off the tray. It has to be planned at first fix and tanked like the rest of the wall.
Tray or tiled floor
A tray is quicker, costs less and has a small lip. A tiled floor with a linear drain sits level with the rest of the room and lets one tile run throughout.
Tray length
Go long rather than wide. A 1400 to 1700 mm tray with a 900 to 1200 mm panel leaves a dry walkway; a 1200 mm tray works but gives less margin for spray.
Rules that apply in Scotland
Fitting a walk-in shower does not need planning permission. The light and fan above the shower are in zone 1 up to 2.25 m and must be at least IPX4, or IPX5 where water jets are used, with 30 mA RCD protection on every circuit under BS 7671. Under the water fittings rules, a shower pump may only be used on a gravity system with a cold tank, never on the mains, and the shower needs protection against water flowing back into the supply.
In Scotland, a straight swap from a bath or enclosure to a walk-in shower does not normally need a building warrant, though altering the drainage may. Water fittings must meet the Scottish Water Byelaws 2014.