What does a walk-in shower cost in the Forth Valley?
Our guide range in the Forth Valley is £2,400–£5,800 including VAT. Prices in the Forth Valley run at about 4% below the UK guide, based on Scotland labour rates.
Tray and screen
- Thermostatic mixer and riser rail
Frameless upgrade
- Large-format tiles, niche
Tiled level floor
- Floor former, tanking and linear drain
Guide prices for Forth Valley including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in the Forth Valley?
Supplies across most of the Forth Valley are soft. If that holds for your street in Stirling, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Stirling shower enclosure has a leaking door seal or a cracked tray, a walk-in panel removes the door altogether.
What the job includes
- Removal of the old bath or enclosure and making good to the walls and floor
- An 8 mm or 10 mm toughened glass panel with a wall profile and support arm, or a frameless fixing
- A survey of the space, the waste position, water pressure and the hot-water system
- Tanking to the shower walls, and to the floor where it is tiled
- A low-profile stone-resin tray, or a floor former with a linear drain for a tiled level floor
- Silicone, a full-flow test for leaks and spray, and handover
Decisions to make first
Tray length
Go long rather than wide. A 1400 to 1700 mm tray with a 900 to 1200 mm panel leaves a dry walkway; a 1200 mm tray works but gives less margin for spray.
Valve
An exposed bar valve with a riser rail is easy to fit and service. A concealed valve hides the pipework and suits a fixed overhead head.
Head
A large overhead head feels luxurious but needs good flow. A handset on a riser is easier for rinsing hair and cleaning the shower.
Tray or tiled floor
A tray is quicker, costs less and has a small lip. A tiled floor with a linear drain sits level with the rest of the room and lets one tile run throughout.
Rules that apply in Scotland
Fitting a walk-in shower does not need planning permission. The light and fan above the shower are in zone 1 up to 2.25 m and must be at least IPX4, or IPX5 where water jets are used, with 30 mA RCD protection on every circuit under BS 7671. Under the water fittings rules, a shower pump may only be used on a gravity system with a cold tank, never on the mains, and the shower needs protection against water flowing back into the supply.
In Scotland, a straight swap from a bath or enclosure to a walk-in shower does not normally need a building warrant, though altering the drainage may. Water fittings must meet the Scottish Water Byelaws 2014.