What does a new shower cost in Devon?
Our guide range in Devon is £450–£3,600 including VAT.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Devon including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Devon?
Supplies across most of Devon are soft. If that holds for your street in Plymouth, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. We test pressure and flow at Plymouth surveys before recommending a shower, so you know how it will perform before you buy.
What the job includes
- A check of your hot-water system, water pressure and flow rate
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Electrical connection by a qualified electrician, tested and certified
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- A bath screen, tray or enclosure where the shower is new
Decisions to make first
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.