Shower installation in Queensferry

Postcode districts: EH30
Nearby: Broxburn, Dunfermline and Currie
Guide price: £450–£3,400
Typical time on site: half a day to 3 days
Water: Soft across most of Edinburgh
Survey: Free, at your home

What does a new shower cost in Queensferry?

In Queensferry, a new shower typically costs £450–£3,400 including VAT, based on Scotland prices. Labour costs in Scotland put local prices at about 4% below the UK guide figure. The figure depends on the size of the room, whether anything moves, and the products you pick.

Shower swap

£450–£950

Test and handover

Typical

New shower over bath

£750–£1,750

Thermostatic bar shower and riser

New shower with enclosure

£1,450–£3,400

Pipework and waste

Guide prices for Queensferry including VAT. Your itemised written quote after the free survey is the price that counts.

Working in Queensferry

In Queensferry we cover EH30; we also cover Broxburn, 4.8 miles away, and Dunfermline.

Queensferry gets the same process as anywhere else: a free survey at your home and a written, itemised quote. If you are replacing a failed electric shower in Queensferry, we check whether the existing cable and circuit suit the new unit. If the shower in your Queensferry home swings between hot and cold, a thermostatic valve is usually the fix.

Supplies across most of Edinburgh are soft. If that holds for your street in Queensferry, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier.

What the job includes

New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
Removal of the old shower, a full-flow test and a handover on isolating and descaling it
Electrical connection by a qualified electrician, tested and certified
Supply and fitting of the shower valve or unit, riser rail, handset or fixed head

Decisions to make first

Power shower

A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.

Thermostatic mixer

Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.

Rules that apply in Scotland

In Scotland there is no Part P, but a new shower circuit must still be designed, installed and certified to BS 7671. Water fittings, including pumps and backflow protection, are covered by the Scottish Water Byelaws 2014.

More about shower installation

Shower installation in Queensferry: questions

How much does a new shower cost in Queensferry?

A new shower in Queensferry usually costs £450–£3,400 including VAT. Room size, layout changes and your choice of products move the figure within that range. The free survey gives you an itemised quote, fixed in writing once the details are agreed.

Do you cover EH30 in Queensferry?

Yes. We cover all of Queensferry, including EH30, and nearby Broxburn, Dunfermline and Currie. Survey visits are free and arranged at a time that suits you.

Is the water hard in Queensferry?

Will a new shower in Queensferry need a building warrant?

Usually not for a straight refit. Building warrants are issued by the local council's building standards service, and forming a new bathroom, changing drainage or structural work can need one. We tell you at the survey and handle the application if one is needed.

Which type of shower do I need?

The type depends on your hot-water system. With a combi boiler or unvented cylinder, a thermostatic mixer on mains pressure is usually right. With a cold tank and hot cylinder, a mixer runs by gravity, or a power shower or pump can boost it. If hot water is limited, an electric shower heats cold mains water as you use it. Our guide to choosing a shower goes further.