What does a new shower cost in Lanarkshire?
Our guide range in Lanarkshire is £450–£3,400 including VAT. Prices in Lanarkshire run at about 4% below the UK guide, based on Scotland labour rates.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Lanarkshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Lanarkshire?
- East Kilbride
- Hamilton
- Cumbernauld
- Coatbridge
- Airdrie
- Motherwell
- Rutherglen
- Cambuslang
- Wishaw
- Bellshill
- Blantyre
- Larkhall
Water across much of Lanarkshire is soft. If that holds for your street in East Kilbride, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. If you are replacing a failed electric shower in East Kilbride, we check whether the existing cable and circuit suit the new unit.
What the job includes
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Electrical connection by a qualified electrician, tested and certified
- A bath screen, tray or enclosure where the shower is new
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
Decisions to make first
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Electric shower
Heats cold mains water as it flows, so it works without stored hot water. Higher kW units give more flow; 8.5 to 10.5 kW models need a dedicated circuit, often 40 to 45 amps.
Rules that apply in Scotland
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In Scotland there is no Part P, but a new shower circuit must still be designed, installed and certified to BS 7671. Water fittings, including pumps and backflow protection, are covered by the Scottish Water Byelaws 2014.