What does a new shower cost in Lincolnshire?
Our guide range in Lincolnshire is £450–£3,400 including VAT. Prices in Lincolnshire run at about 4% below the UK guide, based on East Midlands labour rates.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Lincolnshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Lincolnshire?
Supplies across most of Lincolnshire are hard. If your supply in Lincoln is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. If you are replacing a failed electric shower in Lincoln, we check whether the existing cable and circuit suit the new unit.
What the job includes
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
- A check of your hot-water system, water pressure and flow rate
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- A bath screen, tray or enclosure where the shower is new
- Electrical connection by a qualified electrician, tested and certified
Decisions to make first
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Head and handset
A handset on a riser rail is versatile and easy for rinsing; a fixed overhead head feels generous but needs strong flow behind it.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.