What does a new shower cost in Derbyshire?
Our guide range in Derbyshire is £450–£3,400 including VAT. Prices in Derbyshire run at about 4% below the UK guide, based on East Midlands labour rates.
Shower swap
- Like-for-like mixer or electric shower
New shower over bath
- Bath screen
New shower with enclosure
- Tiling to the enclosure
Guide prices for Derbyshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Derbyshire?
- Derby
- Chesterfield
- Long Eaton
- Ilkeston
- Swadlincote
- Staveley
- Belper
- Heanor
- Alfreton
- Dronfield
- Ripley
- Buxton
- New Mills
- Glossop
Water across much of Derbyshire is moderately hard. A quick wipe of the glass and an easy-clean coating are worth having on a new shower in Derby. Hardness varies street by street, so check the figure for your postcode with your water supplier. For Derby homes with a cold tank in the loft, we check the system before fitting anything, because a pump is only allowed on a gravity supply.
What the job includes
- Electrical connection by a qualified electrician, tested and certified
- New pipework and isolation valves, plus a pump only where the system is gravity-fed from a cold tank
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- A check of your hot-water system, water pressure and flow rate
- Removal of the old shower, a full-flow test and a handover on isolating and descaling it
Decisions to make first
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.