What does a new shower cost in Nottinghamshire?
Our guide range in Nottinghamshire is £450–£3,400 including VAT. Prices in Nottinghamshire run at about 4% below the UK guide, based on East Midlands labour rates.
Shower swap
- Test and handover
New shower over bath
- Thermostatic bar shower and riser
New shower with enclosure
- Pipework and waste
Guide prices for Nottinghamshire including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Nottinghamshire?
- Nottingham
- Mansfield
- Worksop
- Newark on Trent
- Arnold
- West Bridgford
- Sutton in Ashfield
- Hucknall
- Kirkby in Ashfield
- Retford
- Eastwood
- Mansfield Woodhouse
Most of Nottinghamshire has hard water. If your supply in Nottingham is the same, limescale on shower glass and heads is a real issue: easy-clean glass, rub-clean nozzles and a squeegee make a big difference. Hardness varies street by street, so check the figure for your postcode with your water supplier. If your Nottingham bath has no shower over it, a thermostatic bar shower, screen and tiling can usually be added in a day or two.
What the job includes
- A check of your hot-water system, water pressure and flow rate
- A bath screen, tray or enclosure where the shower is new
- For an electric shower, a check of the consumer unit and whether a new dedicated circuit is needed
- Electrical connection by a qualified electrician, tested and certified
- Supply and fitting of the shower valve or unit, riser rail, handset or fixed head
- Tiling or re-tiling around the shower, with tanking behind new tiles in the wet area
Decisions to make first
Exposed or concealed
An exposed bar valve fixes onto the tiles and is easy to service. A concealed valve sits in the wall for a cleaner look but needs careful setting-out and a plan for access.
Digital shower
A wall panel sets the exact temperature and flow, while the mixing valve sits out of sight. It needs a power supply and suits a clean, concealed look.
Power shower
A mixer with a built-in pump, for tank-fed systems only. It lifts a weak gravity shower but must never be connected to the mains.
Thermostatic mixer
Blends hot and cold from your system and holds the temperature steady when someone runs a tap. The usual choice with a combi or an unvented cylinder.
Rules that apply in England
The water fittings regulations in each nation do not allow a pump to be connected directly to the mains supply; shower pumps are for gravity systems with a cold tank only. The shower must also be protected against water flowing back into the supply. Electrics must meet BS 7671, with 30 mA RCD protection and at least IPX4 fittings in zone 1, or IPX5 where water jets are used.
In England, an electric shower usually needs its own dedicated circuit, often 40 to 45 amps for an 8.5 to 10.5 kW unit, and a new circuit is notifiable under Part P. The Part G limit of 48 °C applies to a new bath in a new dwelling or one created by change of use, not to a shower, but a thermostatic valve gives similar protection. An unvented cylinder fitted to improve the shower must be installed by a G3-qualified installer.