What does a walk-in shower cost in Renfrewshire and Inverclyde?
Our guide range in Renfrewshire and Inverclyde is £2,400–£5,800 including VAT. Prices in Renfrewshire and Inverclyde run at about 4% below the UK guide, based on Scotland labour rates.
Tray and screen
- Thermostatic mixer and riser rail
Frameless upgrade
- Large-format tiles, niche
Tiled level floor
- Floor former, tanking and linear drain
Guide prices for Renfrewshire & Inverclyde including VAT. Your itemised written quote after the free survey is the price that counts.
Which towns do we cover in Renfrewshire and Inverclyde?
Supplies across most of Renfrewshire and Inverclyde are soft. If that holds for your street in Paisley, limescale on shower glass and heads builds up slowly and a squeegee after use is usually enough. Hardness varies street by street, so check the figure for your postcode with your water supplier. In a long, narrow Paisley en-suite, a walk-in tray along the back wall often works better than a square enclosure.
What the job includes
- A thermostatic valve with a riser rail, a fixed head or both
- Removal of the old bath or enclosure and making good to the walls and floor
- A low-profile stone-resin tray, or a floor former with a linear drain for a tiled level floor
- An 8 mm or 10 mm toughened glass panel with a wall profile and support arm, or a frameless fixing
- Silicone, a full-flow test for leaks and spray, and handover
- Wall tiling, with an optional recessed niche
Decisions to make first
Valve
An exposed bar valve with a riser rail is easy to fit and service. A concealed valve hides the pipework and suits a fixed overhead head.
Tray length
Go long rather than wide. A 1400 to 1700 mm tray with a 900 to 1200 mm panel leaves a dry walkway; a 1200 mm tray works but gives less margin for spray.
Niche
A recessed shelf in the back wall keeps bottles off the tray. It has to be planned at first fix and tanked like the rest of the wall.
Glass thickness
8 mm toughened glass is standard; 10 mm feels heavier and more solid. An easy-clean coating keeps limescale off clear glass in hard-water areas.
Rules that apply in Scotland
Fitting a walk-in shower does not need planning permission. The light and fan above the shower are in zone 1 up to 2.25 m and must be at least IPX4, or IPX5 where water jets are used, with 30 mA RCD protection on every circuit under BS 7671. Under the water fittings rules, a shower pump may only be used on a gravity system with a cold tank, never on the mains, and the shower needs protection against water flowing back into the supply.
In Scotland, a straight swap from a bath or enclosure to a walk-in shower does not normally need a building warrant, though altering the drainage may. Water fittings must meet the Scottish Water Byelaws 2014.